Operating instructions cutting inserts, Attention – Ernesto Multi Slicer User Manual
Page 5
5
GB
Figure 2: Always lay in the cutting insert so that the desired insert lies
in cutter position 1.
Operating instructions cutting inserts
When positioning the cutting insert take care to ensure that the slightly rounded narrow side of the blade
insert lies in line with the cutting lower part.
The blades are extra sharp for optimum cutting results. Please take care not to touch the blades with your
hands when using the device. This is reason enough to keep the device out of reach of children!
Please pay attention that the food to be cut is not bigger than the cuttings blades. To ensure a proper
cutting process the food has to be smaller than the cutting blades!
Attention!
Lift up the cutting upper part to place the desired cutting insert inside. To
do this, first slide the cutting insert into the lower part so that the slightly-
rounded narrow side of the cutting insert fits into the corresponding notch
in the frame of the lower part. Now press down the other side of the
cutting insert, until you hear a click.
Place the food you want to cut onto the blades (cutter position 1).
For cutting large pieces, or pieces to be cut along their lengths, hold the
food to be cut in position by one hand and gently press the cutting upper
part downwards with the other hand, so that it cannot slip to one side.
Then, with a bold movement, press the cutting upper part downwards
with both hands. The food to be cut is pressed downwards with the raster
through the blades in evenly-sized dice, sticks or slices (depending on the
cutting insert) and automatically collected in the transparent collection
box.
To open the collection box and to remove the cut food, simply lift up the
complete cutting lid (cutting upper part and cutting lower part) on the
narrow side and remove it. While doing so, hold the transparent collection
box with the other hand.
At the outside end of the cutting lower part there is a recessed grip. This helps you to remove the cutting insert
by lifting slightly.
Cutter position 1
Cutter position 2
Figure 2: