Emerson P/N 400361-00 - Manual (Page 115)

Parameter Descriptions www.emersonct.com 101
the queue and remain inactive until all data has been
removed from the queue.
Queue Exit
Queue.#.QueueExit
This event activates when the source parameter is equal to
the QueueExitPosition. Queue Exit deactivates when the
Queue Remove instruction is processed.
Queue Exit Position
Quene.#.ExitPosition
Queue Exit Position is the sum of Queue Data Out and the
Queue Offset. When the Queue Exit Position is equal to the
selected source parameter. Then the Queue Exit event
activates. Queue Exit position is only updated when the
first piece of data is put into the queue or when a Queue
Remove instruction is processed.
Queue Full
Queue.#.QueueFull
The Queue Full source will activate if the number of pieces
of data in the queue equals or exceeds the Full Level
parameter. The source will deactivate when the number of
pieces of data in the queue is less than the Full Level.
Queue Offset
Queue.#.QueueOffset
The Queue Offset is the value that is added to the Queue
Data Out and then compared to the source parameter to
determine when the Queue Exit event activates. For
instance, if Comparator Select is set to Feedback Position,
and the Queue Offset is set to 10, and the user puts the
value 5 into the queue, the queue exit function will activate
when the Feedback Position is equal to 5 + 10 or 15.
Queue Overflow
Queue.#.QueueOverflow
This source activates when there is no more room in the
queue to store data. The maximum number of pieces of
data is determined by the Queue Size parameter.
Queue Remove
Queue.#.Remove
The Queue Remove instruction is used in the program to
remove data from the queue. When processed, the oldest
piece of data will be deleted out of the queue. The Queue
Remove instruction also deactivates the Queue Exit
function.
Queue Source
Queue.#.Source
The Queue Source determines which parameter the sum
of the Queue Data and Queue Offset are compared to in
order to activate the Queue Exit function. If set to Position
Feedback, the sum of the data and offset are compared to
the Position Feedback parameter. If set to Master Position,
then the sum is compared to the Master Feedback Position
parameter, and if set to Command Position, then the sum
is compared to the Motor Commanded Position.
Rotary Rollover Enable
RotaryRolloverEnable
This parameter is used in applications with a predefined
repeat length. One example would be a rotary table with a
rotary rollover position of 360 degrees. The position will
rollover to zero when the axis position gets to 360 degrees.
(358, 359, 359.999, 0.0000, 1, 2, and so on.) The rollover
point is defined to be exactly the same position as 0.
Selector Input Destinations
Selector.SelectLinesUsed
The selector is a binary to decimal decoder. This
parameter selects the number of destinations (input lines)
to be used by the selector. The number of lines used
determines the number of sources (selections) that can be
made by the selector; that is 2 input lines can select 4
destinations (selections), 5 input lines can select 32
destinations. Range is 1 to 8.
Select
Selector.#.Select
This source selects Binary inputs to the selector, usually
assigned to input lines. This is level sensitive.
Selection
Selector.#.Selection
This source selects Decimal outputs from the selector,
assigned to indexes, homes or programs.
Initiate
Selector.SelectorInitiate
When this destination is activated, the selector checks the
status of all Selector.Select destinations to determine
which Selector.Selection to activate.
Slot 1 Error Status
Slot1.ErrorStatus
If the Unidrive SP trips due to an error in an option module
populated in Slot 1, this parameter will store/display the