Casio PL-40R 5 - Manual (Page 13)

A-29
MIDI Data Format
Format
pp .......Program Number = 00H to 7FH
Recognition
When a Bank Select MSB value other than 00H is received
by the drum part at the same time as the program change
message, that value is ignored and program change is
performed as if the value were 00H.
Send
Program Change messages are sent when you select a tone
on the instrument.
Format
vv........Pressure Value = 00H to 7FH
Recognition
Use System Exclusive messages to select a type of channel
pressure.
Send
This message cannot be sent.
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
ll..........Pitch Bend Change LSB = 00H to 7FH
mm .....Pitch Bend Change MSB = 00H to 7FH
Recognition
Š The value llH mmH is 00H 00H at the lowest pitch, 00H
40H at mid-pitch, and 7FH 7FH at the highest pitch.
Š You have to set both the LSB and MSB together to form a
14-bit value and make a Pitch Bend Change message
recognized by the instrument.
Send
This message cannot be sent.
J All Sound Off
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
Recognition
Receipt of this message immediately mutes all tones
playing over the MIDI channels.
Send
This message cannot be sent.
Program Change
Byte 1 Byte 2
CnH ppH
Channel Pressure
Byte 1 Byte 2
DnH vvH
Pitch Bend Change
Byte 1 Byte 2 Byte 3
EnH llH mmH
Channel Mode Message
Byte 1 Byte 2 Byte 3
BnH 78H 00H
426-E-121A
PL40NE01-1.book 29 ページ ２００２年７月２３日 火曜日 午後６時５２分