Emerson IFT9701 - Manual (Page 27)

Model IFT9701 Transmitter Instruction Manual 19
Ge
tti
n
g
Sta
rted
P
o
wer
Su
pp
ly
an
d O
u
tp
ut Wi
ri
ng
Mounting the
Remo
te T
ransmitter
Be
fo
re
Y
o
u
Begin
Chapter 4
Power Supply and Output Wiring
4.1 Overview
To wire the transmitter power supply and outputs:
• Review the wiring guidelines (see Section 4.2)
• Connect the power supply wiring (see Section 4.3)
• Connect the output wiring (see Section 4.4)
4.2 Wiring guidelines
• Install cable and wiring so they meet local code requirements.
• The transmitter has two separate ¾-inch NPT or M20 female conduit openings, which must
remain sealed to keep the transmitter watertight. See Figure 4-1 and Figure 4-2.
• The transmitter has a sensor wiring compartment for intrinsically safe sensor wiring, and a
field wiring compartment for non-intrinsically safe power supply and output wiring. See
Figure 4-1 and Figure 4-2.
- For power supply and output wiring, loosen the four captive screws that secure the cover
of the field wiring compartment.
- Access to the sensor wiring and circuit board compartments is not required for power
supply and output wiring.