Powerplus POWX0761 FLIPOVER 1400W 216MM EN - Manual (Page 11)

POWX0761
EN
Copyright © 2008 VARO P a g e | 11 www.varo.com
8.2 Maintaining maximum cutting capacity (Fig. 7)
This tool is factory adjusted to provide the maximum cutting capacity for a 255 mm saw blade.
When installing a new blade, always check the lower limit position of the blade and if
necessary, adjust it as follows:
CAUTION:
When making this adjustment, unplug the tool.
First, unplug the tool. Lower the handle completely. Use the wrench to turn the adjusting bolt
until the periphery of the blade extends slightly below the top surface of the turn table at the
point where the front face of the guide fence meets the top surface of the turn table. With the
tool unplugged, rotate the blade by hand while holding the handle all the way down to be sure
that the blade does not contact any part of the lower base. Readjust slightly, if necessary.
CAUTION:
After installing a new blade, always be sure that the blade does not contact any part of the
lower base when the handle is lowered completely. Always do this with the tool unplugged.
This tool can be used with or without the lower limit by shifting the lower limit stopper as
shown in the figure. (Fig. 8 - 15)
To use the tool without the lower limit, turn the stopper end counterclockwise. Use in this
position is proper to cut a wide and thin workpiece.
To use the tool with the lower limit, move the stopper end clockwise. Use in this position is
proper to cut a thick workpiece.
8.3 Adjusting the Mitre angle (Fig. 9 & 10)
Loosen the clamping screw on the guide fence by turning counterclockwise. Turn the turn
table by handle. When you have moved the handle to the position where the pointer points to
the desired angle on the Mitre scale, securely tighten the clamping screw clockwise.
CAUTION:
 When turning the turn table, be sure to raise the handle fully.
 After changing the Mitre angle, always secure the turn table by tightening the clamping
screw firmly.
8.4 Adjusting the bevel angle (Fig. 11 & 12)
8.4.1 In the Mitre saw mode
To adjust the bevel angle, loosen the lever at the rear of the tool counterclockwise. Push the
handle to the left to tilt the saw blade until the pointer points to the desired angle on the bevel
scale. Then tighten the lever clockwise firmly to secure the arm.
CAUTION:
 When tilting the saw blade, be sure to raise the handle fully.
 After changing the bevel angle, always secure the arm by tightening the lever clockwise.
8.4.2 In the table saw mode (Fig. 13)
To adjust the bevel angle, loosen the lever under the table at the front of the tool
counterclockwise. Move the depth adjusting knob to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale. Then tighten the lever clockwise firmly
to secure the arm.