Powerplus POWX0761 FLIPOVER 1400W 216MM EN - Manual (Page 22)

POWX0761
EN
Copyright © 2008 VARO P a g e | 22 www.varo.com
11.2 Replacing carbon brushes (Fig. 73 & 74)
Remove and check the carbon brushes regularly. Replace when they wear down to the limit
mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes
should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to
remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
11.3 After use
 After use, wipe off chips and dust adhering to the tool with a cloth or the like to assure
maximum service life. Keep the blade guards clean according to the directions in the
previously covered section titled “Blade guard”. Lubricate the sliding portions with machine
oil to prevent rust.
 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by an Authorized Service Centers, always using original
replacement parts.
11.4 Service
Only qualified specialist personnel and original replacement parts should be used for repairs.
This will ensure that your device remains safe.
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by a
qualified person (qualified electrician).
12 TECHNICAL DATA
Type POW X0761
voltage - Frequency 230V - 50Hz
Power 1400 W
No load speed 5000 rpm
Blade TCT - 216 x 30 x 2.6 mm - 60T
tabel height 710mm
Net weight 26kg
Safety class II / double insulated
Mitre Saw :
Max. Cutting capacity
0° - 90° 58x120
45° - 90° 40x120
0° - 45° 58x85
45° - 45° 40x85
Table saw
Table size (W x L) 465x395mm
Max. Cutting capacity
90° 52mm
45° 25mm