Powerplus POWXG6107T LAWNMOWER 1600W 420MM +GRASS TRIMMER EN - Manual (Page 7)

POWXG3009
EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
8 OPERATION
8.1 Switching on/off
 Connect the cable to the power.
 To switch on, you need to keep the safety lock button (4) pressed in and then keep the
on/off switch (2) depressed.
 To switch off, release the switch lever.
WARNING. The tool runs for approximately 5 seconds after it has been
switched off. Let the motor came to a complete stand still before setting the
tool down.
Follow these steps to operate the trimmer:
1.
Make a loop with the extension cable and wrap it through the cord lock.
2. Place the end of the loop around cable securing hook and ensure it is pulled firmly
enough to prevent it coming loose while operating the trimmer.
3. Insert the plug into the extension cable.
4. Hold the trimmer at waist level.
5. Place the product on the right side of your body with the motor behind and away from
your body.
6. Start the trimmer and approach the area to be cut.
7. For best cutting, swing the trimmer gently from side to side and walk forward while
keeping the trimmer at an angle of 30 degrees to achieve best cutting results.
8. Do not overload your trimmer. It operates best at high speed.
9. To cut long grass, start at the top, take several small cuts. Never cut wet or very damp
grass.
10. After finishing the cutting operation, keep the head close to ground level, release the
switch and allow the motor to come to a complete stand still. Place the trimmer on the
ground, switch off and remove the cable plug from the mains supply.
Periodically clean out the grass between the knife and the rim of the guard
to prevent the tool from vibrating.
9 CLEANING AND MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off and unplug the
tool.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.