Powerplus POWXG6460 SHREDDER 2600W SIL ENT EN - Manual (Page 8)

POWXG6460 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
 If the machine becomes clogged, shut of the power source and disconnect the spark plug
wire from the spark plug (electric unit disconnect from supply) before clearing debris. Keep
the power source clear of debris and other accumulations to prevent damage to the power
source or possible fire. Remember that operating the starting mechanism on engine
powered machines will still cause the cutting means to move
 Keep all guards and deflectors in place and in good working condition
 Do not tamper with the power source governor settings; the governor controls the safe
maximum operating speed and protects the power source and all moving parts from
damage caused by over speed. Seek authorized service if a problem exists.
 Do not transport this machine while the power source is running
 Shut off the power source and disconnect the spark plug lead (electric unit disconnect
from supply) whenever you leave the work area
 Do not tilt the machine while the power source is running
6.3 Maintenance and storage
 When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the spark plug wire from the spark plug
(electric unit disconnect from supply), make sure that all moving parts have come to a
complete stop and, where a key is fitted remove. Allow the machine to cool before making
any inspections, adjustments, etc
 Store the machine where fuel vapor will not reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Allow the machine to cool before storing.
 When servicing the cutting means be aware that, even though the power source will not
start due to the interlock feature of the guard, the cutting means can still be moved by a
manual starting mechanism.
7 ASSEMBLY INSTRUCTIONS
Warning! You may need assistance when lifting the machine out of the box
and assembling.
Open the package and remove the machine from package. (Fig 2)
Pull out the collect box and take out the main part of the machine and all accessories.
 Take all parts out of the package. Be sure four protruding supports in the bottom of the
motor unit pass through four notches in the upper face of the base frame. (Fig. 3)
 Slide the collection box out of the base frame. (Fig. 4)
 Fit the front wheel sets to the base frame with the aid of two screws. (Fig. 5)
 Use the spanner to mount wheels to the base frame using two wheel shafts, two
grommets, two spring grommets and two screws. Assemble cap by pushing in on by hand.
(Fig. 6)
 Slide the collection box back to the base frame. Ensure that the collection box runs above
the guide rails. (Fig. 7)
 Stand and put hands in position as shown in Fig. 8. Lay the motor unit on the base frame
by placing four protruding supports (Fig. 8/Item B) of the motor unit on the slots (Fig. 8-
1/Item A) of the base frame.
 Fix the location plate to the base frame with two screws. (Fig. 9)
 Lock the collection box with safety switch in position by pushing upwards. (Fig. 10-1)