Powerplus POWXG6460 SHREDDER 2600W SIL ENT EN - Manual (Page 9)

POWXG6460 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
7.1 Collect box locking handle
 Your shredder is equipped with a safety switch,
it does not work when this switch is not pushed
by the collect box locking handle.
 After sliding in the collect box you have to
move the ‘collect box locking handle’ upwards,
to close the safety switch. Then only you can
start the shredder.
 To Remove collect box : before you can
remove it, you have to pull t
he ‘collect box
locking handle’’ down. When collect box is not
in its place, the shredder can not not be
operated. NOTE ! After re-placing the collect
box, you always have to push the ON switch to
make shredder work again.
8 OPERATION
8.1 Putting into operation
Before you plug the connection cable of the mains
supply into the socket, you have to retract the grey
"pull-out" protection, plug in the socket and then let
spring back the protection. Otherwise caused by
vibrations the plug will be disconnected from the
socket.
8.2 On/off switch
 Press the green button to switch on the shredder.
Inrush currents can cause short-time voltage drops; under unfavourable power supply
conditions, other equipment may be affected (if the system impedance of the power supply is
lower than 0,127 + j0,079 Ohm, disturbances are unlikely to occur); if you need further
clarification, you may contact your local power supplier.
 Press the red button to switch it off.
Note: This machine is equipped with an electromagnetic switch to prevent it
from being unexpectedly switched on when power source recovered.