Powerplus POWXG8010LI GRASS TRIMMER 18V LI-ION ONE FITS ALL EN - Manual (Page 10)

POWXG8010LI
EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
 Press both locking tabs of spool cover simultaneously and remove.
 Remove cord spool
 Clean, if necessary
 Insert cord spool into housing.
 Thread the end of the wire through the eye of the wire box
To avoid inadvertent unwinding, do not take wire on the new spool out
through the support holes before inserting.
 Place the spool cover on the cord spool holder so that locking tabs lock into place.
Before switching on: hold trimmer parallel to the ground; otherwise, there is
danger of injury
11 TECHNICAL DATA
POWXG8010LI
No load speed 8000 min-1
Adjustable handle yes
Cutting circle 300 mm
Battery
Type
Li-ion
Voltage 18VDC
Rating 1500 mAh
Charger :
Input Voltage ~Frequency 230-240VAC, 50-60 Hz, 45W
OUTput voltage / current 19,5 VDC, max. 2,2 A
Battery charger
Type
1 hour fast charger
12 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
77 dB(A)
Acoustic power level LwA 94 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration) 3,6 m/s² K = 1,5 m/s²
13 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).