Powerplus POWXG8010LI GRASS TRIMMER 18V LI-ION ONE FITS ALL EN - Manual (Page 8)

POWXG8010LI
EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
7.4 General instructions:
Regarding the battery, in order to maintain the long service life of the battery, always follow the
instructions below:
 The tool will automatically be switched off when the battery voltage is low. The battery
must then be recharged before the tool can be used again.
 Always recharge the lithium-ion battery prior to any prolonged period of non-use, i.e. before
storing the tool away in autumn.
 The charging time is 1,2 hours for a battery that is completely empty.

The lithium-ion rechargeable battery can be charged at any charge level and charging can
be interrupted at any time without damaging the battery (no memory effect)
8 ADJUSTMENT
8.1 Using Adjustable Handle (fig C/D)
The adjustable handle (4) can be set in various positions:
 To change the position undo the handle knob (3) and move the adjustable handle (4)
 Tighten the handle knob (3) securely to fix the adjustable handle (4) in the desired position.
8.2 Adjusting shaft length(fig. E)
 Loosen the adjustment collar (5)
 Pull the shaft out to increase, or push the shaft in to decrease the height/length.
 Retighten the collar (5).
8.3 Adjusting cutting head angle (fig. F)
The trimmer has 3-adjustable working angles. This allows you to easily reach hard to reach
areas in your garden.
 Press the lock button
 Adjust to the desired working angle (the handle noticeable snaps into places)
While working, the cutting head should be tilted forwards slightly.
 Release the angle adjusting knob.
9 OPERATION
9.1 Cutting and Edging (fig. G)
Remove stones, loose pieces of wood and other objects from the cutting area.
The blade continues to rotate for a few seconds after the trimmer is
switched off.
 Hold the device at the upper and middle grips
 Swing the device in semicircles in front of the body (without touching the ground)
The optimal working angle for cutting is 30°.
 Allow the motor cutting line to stop rotating before switching "on" again.
 Do not rapidly switch off and on.