Powerplus POWXQ5320 TILE CUTTER 750W 180MM EN - Manual (Page 6)

POWXQ5320
EN
Copyright © 2011 VARO P a g e | 6 www.varo.com
5.6 Check damaged parts
§ Before further use of tool, it should be carefully checked to determine that it will operate
properly and perform its intended function.
§ Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting
and any other conditions that may affect its operation.
§ A guard or other part that is damaged should be properly repaired or replaced by an
authorized service centre unless otherwise indicated in this instruction manual.
§ Have defective switches replaced by an authorized service centre.
§ Do not use the tool if the switch does not turn it on and off.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR TILE CUTTERS
§ Make sure that the cutting disc is correctly screened by the guard.
§ Never remove the riving knife. The distance between the cutting disc and the riving knife
should not exceed 5 mm.
§ Do not use cutting discs which are bent, deformed or otherwise damaged.
§ Do not use cutting discs which do not comply with the specifications stated in this manual.
§ Never start cutting tiles before the machine reaches full speed.
§ Never attempt to cut extremely small work pieces. Only cut tiles with a max diameter of
180 mm.
§ Do not leave the work area until the machine has been switched off and the cutting disc
has come to a complete standstill.
§ Never attempt to stop the cutting disc by exerting pressure on the side of the disc.
§ Always unplug the machine before performing any maintenance.
§ Do not use the machine before it has been completely assembled and installed according
to the instructions.
§ Do not perform any design, assembly or Construction activities on the table while the
machine is switched on.
§ Unplug the machine and clean the table before leaving the work area.
6.1 Power supply
§ This tile saw must be connected to an earthed 230V - 50Hz power source.
§ This power source must be secured by a 16A fuse.
§ Your machine is supplied with a 30mA residual current device to protect the user against
electric shock. The device has a test button. Please test this regularly. Preferable before
each work.
§ It can only protect you when the power mains to which the tool is plugged is properly
grounded.
§ Have the proper outlet installed by a qualified electrician.
§ Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
6.2 Diamond blades
§ Only use 180 mm diameter Continuous Rim Wet Diamond blades.
§ DO NOT use larger, segmented or 'turbo' blades, wood sawing blades, or any other
cutting device. Severe bodily injury, and damage to your saw can occur.
§ Inspect blades daily for cracks or uneven wear. Discard cracked, chipped or bent blades!
§ Ensure the blade is mounted with the rotation arrow in the proper direction and is securely
tightened with a wrench.
§ Always ensure a continuous flow of water on both sides of the blade before cutting any
material.
§ Do not operate the machine without all safety guards in position
§ Do not force the material into the blade. Let the blade cut at its own speed.