Powerplus POWXQ5320 TILE CUTTER 750W 180MM EN - Manual (Page 7)

POWXQ5320
EN
Copyright © 2011 VARO P a g e | 7 www.varo.com
7 ADJUSTMENTS
ATTENTION! Disconnect the power plug before carrying out any
adjustments or maintenance.
7.1 Assembling the stand (Fig. 4)
The support brackets and stand legs have corresponding letters for easy assembly.
Tools needed: Adjustable wrench or 13 mm wrenches and philips.
§ Insert stand legs, labeled “A”, into end tubes of the support bracket labeled “A”. Angled
ends of stand legs should face away from each other so they resemble a “V”. Align holes
for hardware. Repeat with second support bracket and legs labeled “B”.
§ Fit leg assemblies into braces. Leg assembly “B” rests on inside of braces. Leg assembly
“A” rests on the outer side. Line up holes in the braces and legs. Install hardware through
holes.
§ Using wrench, tighten hardware.
§ Place stand on level ground and line up grooves under tile saw with brackets on stand.
Position table onto stand.
§ Be sure the tile saw is on level ground and the stand is sturdy before use.
7.2 Installing the splash Hood (Fig. 6-7)
§ Remove bevel table
§ Install the L-shaped splash hood bracket into the lip located under the table behind the
wheel.
§ Install the washers and screw into table and through splash hood bracket then tighten
securely.
Note: be sure that hood bracket is aligned with cutting wheel so that it
does not interfere with material being cut.
§ Align splash hood with wheel and slide over bracket. Line up through holes in splash hood
with slot in splash hood bracket
Note: always adjust splash hood horizontally to table and slightly above tile
thickness. Hood should not be touching tile.
§ Install hex bolt through hood and bracket. Thread knob onto bolt and tighten to desired
height.
§ Replace bevel table
7.3 Installing the overflow drain (fig. 8)
§ Remove bevel table (16)
§ Locate hole on bottom of water fill reservoir
§ Push overflow drain into hole firmly
§ Replace bevel table