Powerplus POWXQ5350 MITRE SAW +UPPER TABLE 1800W 305MM EN - Manual (Page 19)

POWXQ5350
EN
Copyright © 2014 VARO P a g e | 19 www.varo.com
12.2.5 Replacing the saw guide
HAZARD!
 If the saw guide has been damaged, then small pieces can become jammed between the
guide and the saw, which can block the saw blade. Immediately replace a defective saw
guide.
 Remove the saw guide.
 Remove the defective piece by dislodging it with a screwdriver.
 Insert a new piece and click it in position.
 Reinstall the saw guide.
12.3 Modifications
12.3.1 Modifications on the mitre and width guide
 Loosen the attachment screws of the guide.
 Adapt the guide so that it is positioned exactly at right angles to the saw blade, when the
mitre table is in the 0° position.
 Retighten the attachment screws of the guide.
12.3.2 Adapting the sawing depth stop
The sawing depth stop limits the depth to which the saw extends in the saw blade opening.
The saw depth stop must be adapted, if the saw blade makes contact with the table.
 Loosen the attachment screw of the saw depth stop.
 Adapt the saw depth stop in such a way that the saw blade extends up to the mitre and
depth guide in the saw blade opening.
 Retighten the attachment screws of the saw depth stop.
 Lower the saw head until it is stopped by the saw depth stop, and check whether the saw
blade can freely rotate in this position.
12.4 Cleaning
Use a brush, a dust cloth or vacuum cleaner, to remove all wood chips and sawdust from:
o The adjustment facilities
o The operating components
o The motor ventilation openings
o The space under the table gap.
13 TECHNICAL DATA
Rated voltage 230 V~
Rated Frequency 50 Hz
Rated Power 1800 W
Rotation speed 3800 Min-1
Blade size 305 x 30 x 2.8 mm
Disc diameter 305 mm
Cable length 2 m
Max. cutting depth 50 mm
Protection class II
Laser warning label 2
Maximum cutting capacity 90° - 0° 95 x 150 mm