Eclipse - Fujitsu Ten ECLIPSE CD3200 - Manual (Page 69)

How to operate the Sound Adjustment Mode
69
XII
Switching the sound adjustment
mode
The Menu selection mode is activated.
The sound selection mode is
activated.
Each time the button is pressed, the
setting item changes.
PEQ ↔ Position Sel ↔ X-Over ↔ Non-
F Phase ↔ PEQ www
The adjustment mode is switched.
Parametric equalizer adjustment
(PEQ)
The PEQ setting mode is activated.
Setting preset EQ
Pressing the button allows you to
toggle through preset EQ modes as
follows:
ATTENTION
Custom EQ will be overwritten if the value for
BASS, MIDDLE and TREBLE are adjusted in
the audio control mode. (For details, Refer to
"How to operate the AUDIO CONTROL" on
page 64.)
Adjusting the median frequency and
the Q curve
Frequency level and Q curve for 3 bands (BASS,
MIDDLE and TREBLE) can be adjusted
separately. Q curve pattern can be chosen from
Narrow, Normal, MidWide or Wide for BASS,
Narrow or Normal for MIDDLE, and Normal for
TREBLE.
Each time the button is pressed, the
band changes in the following order.
BASS →MIDDLE →TREBLE →www
1
Press the [ /MENU] button for
more than one second.
2
Press the [SELECT] (Up/Down)
button to select SOUND.
3 Press the [ENTER] button.
4
Press the [SELECT] (Up/Down)
button to select a setting item.
5 Press the [ENTER] button.
1
Press the [SELECT] (Up/Down)
button to select PEQ.
2 Press the [ENTER] button.
1
Press a button from [2] to [6] while
the PEQ setting mode is activated.
Button Mode Patterns
[2] DEFEAT No EQ adjustments
[3] POWER The pattern that
emphasize the bass
range.
[4] SHARP The pattern that
emphasize the treble
range.
[5] VOCAL The pattern that
emphasize the middle
range.
[6] CUSTOM Custom pattern
1
Press the [ENTER] button to select
the band to be adjusted.