Setting up the mgp to work with the switcher, Setting up the mgp to work with the switcher, Preliminar y – Extron electronic Multi-Graphic Processor MGP 464 DI User Manual

Page 121

Advertising
background image

PRELIMINAR

Y

6-3

MGP 464 • Special Applications

In this type of configuration, the following occurs:

On the MGP, window 1 displays input 1, window 2 displays input 2, and so

•

forth.
Input switches are made at the matrix switcher instead of at the MGP.

•

Input presets are recalled on the MGP to correctly set up the input coming

•

from the switcher. This setup can include the video signal type; picture

controls; advanced input configuration functions such as setting the active

lines/pixels, total lines/pixels, and pixel phase; and the input name.

You can perform the required MGP setup operations using any of the following:

SIS commands (See chapter 4.)

•

The MGP 464 Web pages (See chapter 5.)

•

The Windows-based control software (See chapter 4 and the software’s

•

Help.)

Setting up the MGP to work with the switcher

Follow these steps to set up the MGP to work with a matrix switcher.
1

.

Install and connect the MGP as described in the “Installation Overview”

section of chapter 2, “Installation,” with the exception of step

3

.

In place of

step 3, do the following:

Connect the MGP’s four fully-configurable inputs to four of the matrix

switcher’s outputs. (See the diagram below.)

Connecting the matrix switcher to the MGP 464

2

.

Size the windows on the MGP to full screen. You can do this quickly by

selecting window preset 1, 31, 61, 91, or 121.

3

.

On the matrix switcher, tie input 1 to the four switcher outputs that are

connected to the MGP 464. (Refer to your matrix switcher user’s manual for

the procedure.)

4.

Select window 1 on the MGP, and configure the input as follows:
a

. Set the following input sampling parameters as desired: signal type,

horizontal and vertical start, total pixels, active pixels, and active lines.

b

. Set the following picture controls as desired: image size, image position,

color, tint, brightness, and contrast.

c

. Set the pixel phase for window 1, then mute the window to display the

next window behind it. Repeat this step for windows 2, 3, and 4.

d

. Save the adjusted settings as Input Preset 1.

Advertising
This manual is related to the following products: