Selecting the video signal type, Configuring the output, Selecting the video signal type -6 – Extron electronic Multi-Graphic Processor MGP 464 DI User Manual

Page 98: Configuring the output -6, Preliminar y, Html configuration and control, cont’d

Advertising
background image

HTML Configuration and Control, cont’d

MGP 464 • HTML Configuration and Control

5-6

PRELIMINAR

Y

To change the name of an input,
1

.

On the Scaler I/O Settings screen, select and delete the text in the box under

the desired input number.

2

.

Enter a name of up to 16 characters for the input. The following characters

may be used:

Symbols:

: / – _ + “

Numerals:

0 through 9

Letters:

Lowercase a through z, uppercase A through Z

Spaces

also can be used.

Selecting the video signal type

Under each input name box is a pull-down menu from which you can select the

video signal type for the input.
Signal type

— RGB, YUV-HD, RGBcvS, DVI (MGP 464 DI and

MGP 464 HD-SDI only), or HD-SDI (MGP 464 HD-SDI

only) are available on inputs 1 through 4 only. YUVi

component video, S-video, and composite video are

available on all inputs.

The virtual inputs (5 through 19) are displayed on the

screen in groups of three, with one drop-down menu for

each set of three inputs.

For each virtual input group,
• If you select YUVi from the menu, all three

inputs in the group are configured together

as one component video input.

• If you select S-Video,Comp, the first (top) two

inputs are configured as S-video and the

third, as composite.

• If you select Comp,Comp,Comp, each input in

the group is configured as composite video.

Film mode

— To place an input in film mode, which enables 3:2 and 2:2 pulldown,

select the Film Mode check box below or to the right of the signal type menu.

If RGB, YUV-HD, DVI, or HD-SDI is selected as the signal type, this check box

is unavailable.

Configuring the output

In the Output Configuration section of the Scaler I/O Settings screen, you can select

output parameters from the following pull-down menus:
Resolution

— Select the resolution at which the image is displayed on the output

screen.

Refresh Rate

— Select the rate in Hz at which the output screen is refreshed.

Sync Format

— Select the output signal type required by the display device.

Available formats are RGBHV, RGBS, RGsB, YUV bi-level and YUV tri-level.

Polarity

— Select the combination of horizontal and vertical synchronization signal

polarities.

Advertising
This manual is related to the following products: