Enviro EG40 BV - Manual (Page 14)

Secondary Installation
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.
4. Upon the first light up, watch for
ignition to ALL burner ports. If a long
delay is noted: First, wait for the appliance
to cool down.
• Open the front door of the appliance.
• Check to carefully reposition the embers
making sure that burner ports are not
plugged solid or blocked.
Important note: When the unit is turned
on for the first time, It should be turned
onto high without the fan on for the first 4
hours. This will cure the paint, logs, gasket
material and the other products used in
the manufacturing process. It is advisable
to open a window or door, as the unit
will start to smoke and can irritate some
people. After the unit has gone through
the first burn turn the unit off including
the pilot, let the unit get cold then remove
the glass door and clean it with a good gas
fireplace glass cleaner, available at your
local ENVIRO dealer.
See Routine Maintenance And Service on
how to remove door to clean glass.
Figure 15: Log Placement with Embers.
Figure 16: Appliance Burning.
14
Figure 14: Step 4 of Log Placement.