Crivit H14347 - Manual (Page 43)

43 GB/MT
Getting started
function. Otherwise the functions of the
pedometer cannot be used properly.
Note: After you have set all the parameters
before using it for the first time, you can
change the parameters at any time. The only
thing you cannot change at a later date is the
unit of measurement (metric or US system). If
you wish to change the unit of measurement,
you will have to remove all the batteries
10 , 11
from the battery compartment 13 or press the
RESET button 12 . This process resets the preset
values again.
Q
Hold mode / count mode
When you start the device, the pedometer is
automatically in
count mode.
Note: In hold mode the measuring func-
tions of the pedometer are disabled.
j Press and hold the MODE button 3 for
about 3 seconds. An acoustic signal will
sound. The display
will flash alter-
nately with the number of the steps.
j Press and hold the MODE button 3 for
approx. 3 seconds to enter count
mode. You will hear a signal. dis-
appears.
Q
Setting parameters
j When you start to operate the device for
the first time or switch the device to
hold
mode (see “Hold mode/counting mode”),
you can set or change various parameters.
j To do so, press the SET button 2 , to get
to set mode. The word “SET” will light
up in the LC display.
j The indicators kg, cm, km or lb, inch, mile 16
flash. Press the buttons MODE 3
or CLEAR 5 to set the desired unit of
measurement (metric or US system).
j Confirm your entry by pressing the SET
button
2 . The word STRIDE will appear
in the function bar 14 . The cm symbol 16
and the preset value 60 cm / 25 inch flash
in the LC display. Press the buttons MODE
3 or CLEAR 5 in order to set the de-
sired length of your stride.
Note: You can specify a stride length of
between 30 to 200 cm / 10 to 80 inch.
tip: Press the MODE 3 or CLEAR 5
button for about 3 seconds. This will speed
up the process of setting the values. You
can use this fast way of setting the param-
eters for the setting procedures that follow.
j Confirm the entry by pressing the SET
button
2 . The word WEIGHT will appear
in the functionbar 14 . The kg symbol 16
and the preset value 60 kg / 120 lb flash
in the LC display. Press the buttons MODE
3 or CLEAR 5 to set the desired weight.
Note: You can specify a weight of
between 30 to 200 kg / 60 to 400 lb.
j Confirm the entry by pressing the SET
button
2 . The word HEIGHT will appear
in the function bar 14 . The preset value
flashes in the LC Display. Press the MODE
3 or CLEAR 5 button to enter the desired
value.
Note: A value between 60 and 250 cm /
20 and 100 inch can be entered.
j Confirm your settings by pressing the
SET button
2 . The LC display shows the
AGE 29 indicator and the number 18 as
the preset value. Press the MODE 3 or
CLEAR 5 button to enter the desired age.
Note: Any age between 5 and 99 years
can be entered.
j Confirm the entry by pressing the SET
button
2 . The words MAN or WOMAN
will light up. Press the buttons MODE 3