Florabest FRP 350 B1 - Manual (Page 7)

7
GB
opening the equipment, are to be car-
ried out by an electrician. In the case
of repairs, always contact our service
centre.
Electrical safety:
Caution: to avoid accidents and
injuries from electric shocks:
• After erection, the mains plug must be
freely accessible when the equipment
is in operation.
• Ensure that the mains voltage matches
the specifications on the rating plate.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA;
minimum fuse 10 amperes.
• Before each use, check the power sup-
ply lead and the extension cable for
damage and ageing. Do not use the
equipment if the cable is damaged or
worn.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent hazards.
• Before each use, check the equipment,
cable and plug for damage. Defective
cables are not to be repaired, but rather
replaced by new ones. Have any dam-
age to your equipment repaired by a
specialist.
• If the supply cord is damaged, it must
be replaced by the manufacture or its
service agent or a similarly qualified
person in order to avoid a hazard.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by the
cable.
• Only use a rubber-sheathed cable des-
ignated H05 RNF for mains connection.
The cable length must be 10 m.
• Protect cables and electrical connec-
tions against moisture. Make sure that
cables and electrical connections are
located in areas safe from flooding.
Intended purpose
The rain barrel pump is intended for
pumping water from a rainwater butt or
rainwater collecting tank. It is particularly
suitable for watering plants in the garden.
Use of the pump for pumping aggressive,
abrasive, corrosive, inflammable (e.g. motor
fuels) or explosive liquids, salt water, clean-
ing agents and foodstuffs is prohibited. The
temperature of the liquid to be pumped must
not exceed 35°C.
The operator or user is responsible for ac-
cidents or damage to other people or their
property.
The manufacturer is not liable for any
damage caused by infringement of the
conditions of use or incorrect operation.
General description
Functional description
The pump is manufactured with a shock-
resistant plastic casing and a stainless
steel motor drive-shaft. It has a cooling
jacket through which the water pumped
flows around the motor to the pressure
connection. The pump is fitted with a float-
ing switch which automatically cuts the
pump in or out, according to the water lev-
el. In the case of an overload, the pump
is cut out by the built-in thermal protection