Florabest FAH 18 C3 - Manual (Page 6)

6
GB
Technical Data
Appliance
Motor voltage ............................. 18 V
Idling speed ................... 1300 min -1 (rpm)
Runtime .............................. max. 50 min*
Cutting length .....................appr. 520 mm
Max. cutting capacity ............appr. 15 mm
Weight (with knife guard,
without battery charger) ..................2.7 kg
Sound pressure level
(L
pA
) .................77.5 dB(A), K
pA
=3 dB(A)
Sound power level (L
wA
)
guaranteed ............................ 93 dB(A)
measured .......91 dB(A); K
wA
=2.09 dB(A)
Vibration (a
h
) ..........................................
Rear handle .... 0.970 m/s 2 , K=1.5 m/s 2
Front handle .... 1.964 m/s 2 , K=1.5 m/s 2
Battery (Li-Ion)
Nominal voltage ......................... 18 V
Capacity ...................................... 1.3 Ah
Charging time ....................... approx. 5 h
Recharger ....................... JLH082100350G
Nominal consumption ......................12 W
Voltage input ... 100-240 V~, 50Hz/60 Hz
Voltage output ................21 V 350 mA
Protection class ................................. II
Protection category ...........................IPX0
* The actual runtime under load of a fully charged
battery depends on how you work and on the load put
on the trimmer during operation.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further develop-
ment without notice. All dimensions, refer-
ences and information in this instruction
manual are therefore not guaranteed. Legal
claims made on the basis of the instruction
manual can therefore not be considered as
valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value de-
pending on the manner in which the
power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
erating cycle are to be considered,
including, for example, times during
which the power tool is turned off
and times when the tool is turned on
but is running idle).
Notes on Safety
This section details the basic safety instruc-
tions for working with the appliance.
Symbols
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction
is explained at the place of the ex-
clamation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.