Epson 500 Series - Manual (Page 93)

MNP Command Summary (continued)
Command Description
\ N 2 Set reliable mode
\ N 3 Set auto-reliable mode
\N4 Set V.42(LAP-M) mode
\ N 5 Set V.42 auto-reliable mode
\ N 6 Set V.42/MNP reliable mode
\ N 7 Set V.42/MNP auto-reliable mode
\ O Force a reliable link independent of whether or not the modem
originated or answered the call
\ Q 0 Disable flow control
\ Q 1 Enable XON/XOFF flow control
\ Q 2
Enable RTS/CTS flow control
\ Q 3 Enable XON/XOFF software flow control
\Q4 Enable unidirectional hardware flow control, keeping CTS off
until connection is established
\ Q 5 Unidirectional, keep CTS of until connection established
\ Q 6
Kept CTS off until connection for bidirectional hardware flow
control established
\ S Display on-line modem status
\T0 Inactivity timer: Disables timer
\T n Sets timer to number (n) up to 90 minutes
\ U Accept a reliable link request independent of whether or not
the modem originated or answered the call
\V0 Disable extended MNP and V.42 result codes
\V1 Enable extended MNP and V.42 result codes
\X0 Disable XON/XOFF pass through, but still process
\X1 Enable XON/XOFF pass through and process
\ Y Establish on MNP reliable link while already connected in direct
m o d e
\ Z Switch to direct mode
&Q5 Select error correction mode
To make on MNP5 connection:
&Q5 plus S36 = 7 (MNP)
S46 = 138 (MNP5)
S48 = 128 (Fallback, no V.42)
To make on MNP4 connection:
&Q5 plus S36 = 7 (MNP)
S46 = 133 (No compression)
S48 = 128 (Fallback, no V.42)
Fax/Modem B-7