Florabest FRT 450 A1 - Manual (Page 48)

48
GB MT
Cut the grass by
swaying the trimmer
sideways to the right
and left. Cut slowly,
keeping the appli-
ance inclined for-
ward slightly when
cutting.
Cut tall grass by a series of levels from
top to bottom.
Cleaning and maintenance
Always disconnect the plug from
the mains socket before working
on the trimmer.
Any work that is not described
in these Instructions must be
carried out by a servicing agen-
cy authorized by us. Only use
original parts and be very care-
ful with the line cutter during in-
stallation work. Danger of injury!
Disconnect the plug from the mains
socket after every use and check the ap-
pliance for damaged parts.
Cleaning
Do not jet water onto the trimmer
and do not clean it under flowing
water. This would result in the
danger of an electric shock and
the trimmer could be damaged.
Always keep the trimmer clean. Do no
use cleaning agents and solvents.
• After the work has been completed
remove all grass and soil from the cut-
ting device and the protective cover
( 8).
• Ensure that the ventilation slots are
always clean and free of grass.
• Clean the trimmer with a soft brush or
a cloth.
Exchanging the line spool
Never manipulate the cutting de-
vice by inserting worn out original
or alien parts. Only use original
spare parts. Never use metal lines.
The use of alien parts can result in
serious personal injury and cause
irreparable damage to the trimmer
and the guarantee will become
instantly null and void.
1. Disconnect the plug from the
mains socket.
2. Turn over the trimmer so that
the cutting head (9) is facing up-
wards.
3. Simultaneously press the two
locks on the cutting head (9) and
remove the hood (17).
4. Remove the line spool (15) from
the cutting head (9).
5. Insert the new spool with the
smooth side facing upwards in
the cutting head and thread the
two lines through the line eyelets
(18). Ensure that the line ends
do not slip out of the spool slots.
6. Return the hood.(17) Ensure that
the locks (19) of the hood are
accurately inserted in the corre-
sponding recesses of the cutting
head. They lock in audibly.
7. Press the retaining head (14),
release it again and pull the ends
of the cord out a little. Repeat this
process until the ends of the cord
project a little beyond the cord cut-
ter (13).