Fitting a pressure pipe, Starting up, Cleaning and maintenance – Florabest FGP 1000 A1 User Manual

Page 9: Replacing the mains cable

Advertising
background image

GB/IE

- 9 -

10. Fitting a pressure pipe

The discharge line (should be min. 19

mm (3/4“)) must be connected approx.

33 mm to the discharge line connection

(R1 female thread) of the pump either di-

rectly or with the aid of a threaded nipple

(Fig. 1/Item 7).

You can also use a pressure hose of ap-

prox. 13 mm (1/2“) with the relevant cou-

plings. The pump rate is reduced when

using the smaller discharge line.

During the priming process, the shut-off

devices present in the discharge line

(spray nozzles, valves, etc.) must be

completely open so that the air in the

intake line can escape freely.

11. Starting up

Place the pump on a firm and level sur-

face.

Before starting the pump, it must be se-

curely mounted on the surface using

the holes in the stand (see Fig. 1/Item 3).

Fit intake line so that it is ready for use.

Fill pump with water at the filler screw

(Fig. 1/Item 6) up to the full point.

During the priming process, the shut-off

devices present in the discharge line

(spray nozzles, valves, etc.) must be

completely open so that the air in the

intake line can escape freely.

The initial intake process can take ap-

prox. 30 seconds to 5 minutes, depen-

ding on the suction height and volume

of air in the intake line. The pump should

be topped up with water if the priming

time is longer.

If the pump is removed after use, it is es-

sential that it is filled with water again the

next time it is connected and started.

Establish electrical connection.

12. Cleaning and maintenance

The pump is largely maintenance-free.

In order to ensure a long service life,

however, we recommend regular checks

and product care.

Caution!

The pump must be disconnected

from the power supply by removing

the power plug before carrying out

any maintenance.

Before lengthy periods of inactivity or

winter storage rinse the pump thorough-

ly, empty it completely and store it in a

dry place.

To drain the pump housing, undo the

water drain screw (Fig. 1/Item 4) and tilt

the pump slightly.

The pump must be completely emptied

if there is a risk of frost.

After relatively long periods of storage,

switch on and off briefly to check whe-

ther the rotor is turning properly.

If the pump is clogged, connect the

discharge line to the water line and dis-

connect the intake line. Open the water

line. Switch on the pump several times

for approx. two seconds. This should

resolve the majority of clog-related pro-

blems.

We recommend lukewarm water to clean

the motor and pump housing.

13. Replacing the mains cable

Caution!

Disconnect the unit from the power sup-

ply! A defective mains cable may only

be replaced by a qualified electrician.

Anleitung_LB6_4171185.indb 9

02.11.11 09:03

Advertising