Florabest FLH 2500 A1 - Manual (Page 14)

14
GB
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
Trouble shooting
Problem Possible cause Fault correction
Motor will not start
Collector box incorrectly at-
tached
Push the collector box home to
its correct position, and place the
safety switch on the box to the ON
position.
Overload protection
To switch back on, start by tur-
ning the operating mode selection
switch ( A 9) to the “OFF” position.
Press the reset switch ( A 7).
Switch the device back on.
No mains power supply
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Safety switch is not prop-
erly in place on the collec-
tor box
Move the safety switch into the ON
position (see section on emptying
the collector box)
Garden waste is
not drawn in
Cylinder running in reverse Change rotational direction using
the switch
Shredding material is too
soft
Insert wood or shred dried branch-
es
cylinder is jammed
Free up the jam
(See section on working methods)
Shredding mate-
rial comes out in
chains
Pressure plate is incorrectly
adjusted
Readjust the pressure plate (See
section on working methods)
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.