Florabest FLH 2500 A1 - Manual (Page 9)

9
GB
Summary
A 1 Wheels
2 Collector box
3 Safety switch
4 Shredder unit
5 Mains cable with strain relief
6 Transport handle
7 Reset switch
8 Funnel feeder
9 Operating mode selection switch
10 Pusher
11 Adjustor screw
12 Chassis
13 Supports
Installation manual
Unpacking
1. Remove the shredder from the
packaging.
B 2. Pull the collector box (2) out of
the chassis (12) and take out the
shredder unit and accessories.
3. Check the scope of delivery:
Scope of delivery
• Operation and Safety Notes
• Shredder unit
• Chassis
• Collector box
• Two running wheels and two adjust-
able feet with assembly material
• Spanner
• Allen key
• Pusher
Assembling the shredder
C
1
Assemble the two running
wheels (1). Clip in the wheel
covers into the running wheels.
2
Screw on the two adjustable feet
(13) to the chassis (12).
3
Fix the cutting attachment (4)
onto the chassis (12) with the
four screws enclosed.
4. To insert the collector box
( A 2), the safety switch(see
picture D ) must be unlocked,
i.e. in the “OFF” position. Push
the collector box ( A 2) into the
chassis ( A 11), with the safety
switch ( A 3) on the side of the
wheels ( A 1). The collector box
( A 2) can be pushed in only in
one direction.
5. Lock the collector box ( A 2) by
pushing the safety switch (Fig
D ) to the ON position.
Operation
Start-up
Before starting the shredder, make sure
that the shredder unit is firmly attached to
the chassis and the collector box and safety
switch are in their proper positions (Fig D ).
The shredder cannot be switched
on before the collector box and
safety switch are in their proper
positions.
Switching the shredder on and
off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.