Florabest FSG 85 B1 - Manual (Page 43)

43
GB MT
from the socket. Keep the cord away
from heat, oil and sham edges.
• Secure work.
Where possible use clamps or a vice
to hold the work. It is safer than using
your hand.
• Do not overreach.
Keep proper footing and balance at all
times.
• Maintain tools with care.
- Keep cutting tools sharp and clean
for better and safer performance.
- Follow instruction for lubricating
and changing accessories.
- Inspect tool cords periodically and
if damaged have them repaired by
an authorized service facility.
- Inspect extension cords periodi-
cally and replace if damaged.
- Keep handles dry, clean and free
from oil and grease.
• Disconnect tools.
When not in use, before servicing and
when changing accessories such as
blades, bits and cutters, disconnect
tools from the power supply.
• Remove adjusting keys and
wrenches.
Form the habit of checking to see that
keys and adjusting wrenches are re-
moved from the tool before turning it
on.
• Avoid unintentional starting.
Ensure switch is in “off” position when
plugging in.
• Use outdoor extension leads.
When the tool is used outdoors, use
only extension cords intended for out-
door use and so marked.
• Stay alert.
Watch what you are doing, use com-
mon sense and do not operate the
tool when you are tired.
• Check damaged parts.
- Before further use of tool, it should
be carefully checked to determine
that it will operate properly and per-
form its intended function.
- Check for alignment of moving
parts, binding of moving parts,
breakage of parts, mounting and
any other conditions that may af-
fect its operation.
- A guard or other part that is dam-
aged should be properly repaired
or replaced by an authorized serv-
ice centre unless otherwise indi-
cated in this instruction manual.
- Have defective switches replaced
by an authorized service centre.
- Do not use the tool if the switch
does not turn it on and off.
• Warning.
The use of any accessory or attach-
ment other than one recommended in
this instruction manual may present a
risk of personal injury.
• Have your tool repaired by a quali-
fied person.
This electric tool complies with the
relevant safety rules. Repairs should
only be carried out by qualified per-
sons using original spare parts, oth-
erwise this may result in considerable
danger to the user.
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.
Further Safety Instructions
• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured re-
sidual current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and