Florabest FBM 135 A1 - Manual (Page 70)

70
GB MT
Alternatively, the following spark
plugs can be used:
- Bosch WR 7 DC
- Champion RN 9Y
- NGK BPR 6 ES
Changing the Engine Oil
Change the engine oil with the
petrol tank empty and the engine
warm.
• Change the engine oil for the
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
• Change the engine oil when the
engine is warm.
• Dispose of the used oil in an
ecofriendly manner (see “dis-
posal / environmental protec-
tion“).
1. Remove the spark plug terminal
( 16) to prevent accidental
starting.
2. Tilt the equipment backward on
the top handle bar (see ) and
place a suitable collecting ves-
sel under the equipment.
3. Loosen the oil drain screw (35)
and allow the used oil to run off.
4. Retighten the oil drain screw
(35).
5. Refill with engine oil (see “Initial
Operation”).
Maintenance Intervals
Regularly carry out the maintenance work listed in the “maintenance intervals” table.
Regular maintenance prolongs the life of the equipment. It also gives optimum cutting
performance and avoids accidents.
Maintenance Work
(See “cleaning and mainte-
nance“)
Before After
After
1 st 5
Hrs.
After
8 Hrs.
After
50 Hrs. Annual
Work
Check and tighten screws,
nuts and bolts

Check the engine oil level /
petrol level and refill with en-
gine oil / petrol if required
 
Clean operating elements / the
area around the silencer
 
Change the engine oil   
Replace the air filter a 
Clean/adjust the spark plug
Replace the spark plug


a Clean more often if there is a high level of dust or heavy dirt