Florabest FBM 575 A1 - Manual (Page 6)

ENGLISH -
DEsCrIPtIoN/CoNtENt of DELIVErY (related illustrations in Appendix A)
AssEMBLY of GrAss CAtCHEr
MuLCHING CAP INsErtIoN
To cut the grass with the mulching system (no grass collection), lift the rear deflector panel and
insert the cap by fixing it with the spring as shown in the figure.
AssEMBLY uPPEr HANDLEs
AssEMBLY LoWEr HANDLEs
1 Clutch lever
2 Engine stop lever
3 Tie strap
4 Fastening knobs for upper handles
5 Lower handles
6 Oil filler cap
7 Fuel cap
8 Spark plug
9 Deck
10 Adjusting lever for cutting height
11 Mulch plug spring
12 Mulch plug
13 Rear deflector
14 Grass catcher
15 Engine start-grip
16 Upper handles
17 Cap
18 Spark plug tool
19 Owners manual
20 Canister 5l
4
IV. Maintenance and Storage
 Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
 Never store the equipment with petrol in the
tank inside a building where fumes may reach
an open flame or spark.
 Allow the engine to cool before storing in any
enclosure.
 To reduce the fire hazard, keep the engine,
silencer, battery compartment and petrol storage
area free of grass, leaves, or excessive grease.
 Check the grass catcher frequently for wear or
deterioration.
 Always use the recommended spark plug type.
Use of the wrong spark plug can damage the
piston/cylinder.
 Replace worn or damaged parts for safety.
Always use genuine spare parts.
 If the fuel tank has to be drained, this should
be done outdoors.
Mount the plastic caps (17) as illustrated in Appendix D. Then mount upper handle with screw,
washer, starter cord guide and knob.
Use the two straps enclosed to secure the control cables
to the left handle bar as shown in fig A and fig D. Place one strap just above the middle folding
knob and the other one 10cm from the lower folding knob. Make sure no cable gets in contact
with the wheel. Tighten straps just enough to hold the cables tight without deforming them.
Start by mounting the steel frame in the hard top part of the bag. Then assemble the lower part
by pressing the plastic list into the upper part slot as illustrated in Appendix B
Mount the lower handle to the clip deck with screw, washer and knob according to illustration in
Appendix C. Insert nut in knob when mounting.