Florabest FLB 2500 A2 - Manual (Page 38)

38
GB
guide rollers at the lower end of the tube
make it easier to guide the tube along the
ground.To.protect.the.user,.the.ap-
pliance.can.only.be.used.with.the.
blowing/suction.pipe.completely.
installed..The.appliance.is.double-
insulated,.and.does.not.need.to.be.
earthed.
Refer to the following descriptions for instruc-
tions on how the operating controls work.
Technical Data
Leaf.blower................ FLB.2500.A2
Rated input voltage .................220-240V,
50/60 Hz
Input power .............................. 2500 W
Safety class ................................... / II
Protection category......................... IP 20
Air capacity .................. max. 15 m 3 /min
Air speed ....................... max. 270 km/h
Shredding rate ........................max. 10:1
Content of the collection bag ............. 50 l
Weight (incl. accessories kit).......... 5,5 kg
Sound pressure level
(L
pA
) ........... 86,0 dB(A); K
pA
= 3,0 dB(A)
Sound power level (L
WA
)
measured ...101,0 dB(A); K
wA
= 2,0 dB(A)
guaranteed ......................... 103,0 dB(A)
Vibration (a
n
)
at the handle .............................9,7 m/s 2
at the additional grip .............9,3 m/s 2;
K=1,5 m/s 2
Noise and vibration values were deter-
mined according to the standards and
stipulations designated in the Declaration of
Conformity.
Noise and Vibration: The operating condi-
tions during measuring and the procedures
used for measuring in accordance with
EN 15503, Appendix A, Appendix B.
Technical and optical changes can be car-
ried out in the course of the further develop-
ment without announcement. All measures,
references and information contained in
this operating manual are therefore without
guarantee. Legal claims, which are made
on the basis of the operating manual, can-
not be considered.
This device is designed for operation on
a power supply network with a system
impedance Zmax at the transfer point
(domestic connection) of a maximum of
0.28 Ohms.
The user must ensure that the device is
operated only on a power supply network
that fulfils this requirement. If necessary,
the local power supply company can be
asked for the system impedance.
Notes on safety
This section deals with the basic
safety regulations to be observed
when working with the machine.
Symbols used in the instruc-
tions
. Hazard.symbol.(explanation.
of.hazard.partly.instead.of.
exclamation.mark).with.in-
formation.on.prevention.of.
personal.injury.and.property.
damage..
Precaution symbol (explanation of
precaution partly instead of excla-
mation mark) with information on
prevention of harm / damage.
Notice symbol with information on
how to handle the device properly.