Florabest FLH 2800 A1 - Manual (Page 13)

13
GB
Trouble shooting
Problem Possible cause Fault correction
Motor not running
or cuts out during
operation
Collector box (2) incorrectly
attached
Push the collector box (2) home to
its correct position, and place the
safety switch (3) on the collector
box (2) to the ON position.
Overload protection
To switch back on, start by turning
the operating mode selection switch
( A 9) to the “OFF” position.
Press the reset switch ( A 7).
Switch the device back on.
No mains power supply
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Safety switch (3) is not prop-
erly in place on the collector
box (2)
Move the safety switch (3) into the
ON position (see section on empty-
ing the collector box)
Garden waste is
not drawn in
Cylinder running in reverse Change rotational direction using
the switch
Shredding material is too
soft
Insert wood or shred dried branches
cylinder is jammed
Free up the jam
(See section on working methods)
Shredding material
comes out in chains
Pressure plate is incorrectly
adjusted
Readjust the pressure plate (See sec-
tion on working methods)