Florabest FLH 2800 A1 - Manual (Page 9)

9
GB
the same or a similarly qualified person in
order to prevent hazards.
• Do not use the appliance if the on/off
switch does not work properly. Always
have a damaged switch repaired by our
Service Centre.
• Only use extension cables that have been
approved for outdoor use and are resist-
ant to splash water. The core diameter for
extension cables measuring up to 25 m
must be at least 2.5 mm², and 2.5 mm²
for cables longer than 25m. Always roll
the whole cable off the reel before use.
Check the cable for damage.
• Do not unplug the shredder by the cable.
Keep the cable away from heat, oil and
sharp edges.
Installation manual
Unpacking
1. Remove the shredder from the
packaging.
B 2. Pull the collector box (2) out of
the chassis (12) and take out the
shredder unit and accessories.
3. Check the scope of delivery:
Assembling the shredder
C
1
Assemble the two running wheels
(1). Clip in the wheel covers into
the running wheels.
2
Screw on the two adjustable feet
(13) to the chassis (12).
3
Fix the cutting attachment (4)
onto the chassis (12) with the four
screws enclosed.
4. To insert the collector box
( A 2), the safety switch(see pic-
ture D ) must be unlocked, i.e. in
the “OFF” position. Push the col-
lector box (
A
2) into the chassis (
A
11), with the safety switch ( A
3) on the side of the wheels ( A
1). The collector box ( A 2) can
be pushed in only in one direc-
tion.
5. Lock the collector box ( A 2) by
pushing the safety switch (Fig D
) to the ON position.
Operation
Start-up
Before starting the shredder, make sure that
the shredder unit is firmly attached to the
chassis and the collector box and safety
switch are in their proper positions (Fig D ).
The shredder cannot be switched
on before the collector box and
safety switch are in their proper po-
sitions.
Switching the shredder on and
off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.
Make a loop at the end of
the extension cable and
hang the loop onto the strain
relief on the mains cable (
A 5).
Connect the extension cable.
Make sure that the funnel feeder is empty.
1. To switch on, push the operating mode
selection switch ( A 9) lock forward