Florabest FLH 2800 A1 - Manual (Page 5)

5
GB
• Collector box
• Two running wheels and two adjust-
able feet with assembly material
• Spanner
• Allen key
• Pusher
See the front fold-out page for il-
lustrations.
Overview
A 1 Wheels
2 Collector box
3 Safety switch
4 Shredder unit
5 Mains cable with strain relief
6 Transport handle
7 Reset switch
8 Funnel feeder
9 Operating mode selection switch
10 Pusher
11 Adjustor screw
12 Chassis
13 Supports
Functional description
The silent shredder is equipped with a power-
ful motor and motor brake, overload protec-
tion with an auto-reverse system, and restart
prevention for additional safety. A blade cyl-
inder system is used for cutting, which works
extremely quietly and automatically draws
in the shredding material. The sturdy chassis
ensures a stable standing position with good
mobility.
Refer to the following descriptions for a
functional description of the controls.
Technical data
Silent shredder ........... FLH 2800 A1
Nominal power intake
.........................2800 W (S6 40% 50s)*
Nominal voltage ...220V-240V AC, 50 Hz
Safety class ..................................... II
Degree of protection ........................ IP24
Branch thickness ...............Max 42 mm**
Collector box content .............Approx 60 l
Weight ........................................ 22 kg
Sound pressure level (L
pA
)
.................... 71,7 dB(A); K
pA
= 2,4 dB(A)
Sound power level
Measured (L
WA
)
....................91,7 dB(A); K
wA
= 2,4 dB(A)
Guaranteed ..................................94 dB(A)
* Continuous-operation periodic duty
(20 s on - 30 s idle)
* * The max. branch thickness that can be
chaffed is dependent on the type of
wood and the quality of the goods be-
ing cut.
For hard wood (e.g. oak/beech
branches), the max. branch thickness
that can be chaffed is less than for soft
wood (e.g. pine/spruce wood). For
dry or knotted wood, the cutting thick-
ness may also be less.
The sound levels have been determined in
accordance with noise measuring process
EN 13683:2009-09, appendix F.
Do not exceed the maximum authorised
network impedance of 0.28 Ohms at the
electrical connection point.
If necessary, confirm with your electric-
ity supplier regarding adherence to this
requirement.