Safety information / preparing for use, Battery safety instructions, Preparing for use inserting or replacing batteries – Melinera Z30771 User Manual

Page 23

Advertising
background image

25

GB/IE

Safety information / Preparing for use

Children or other individuals who do not know

or have no experience of handling this device,
or whose physical, sensory or mental abilities
are restricted, must not use the device without
supervision or instruction by an individual
responsible for their safety. Children must be
supervised in order to ensure that they do not
play with the device.

The product should only be assembled by

experienced persons or by qualified specialists.

Do not position the product near sources of

heat, otherwise the wax of the LED candle

2

could melt and damage the LED.

The LED cannot be replaced.

ATTENTION! Although the LED candle

2

is

made of real wax, it must not be lit in the same
way as you would light a normal wax candle.

Ensure that the candle holder

3

is always

fixed to the lamp body

1

(see Fig. A).

Battery safety instructions

DANGER TO LIFE! Keep bat-

teries out of the reach of children. Do not leave
batteries lying around. There is a risk of children
or animals swallowing them. Consult a doctor
immediately if a battery is swallowed.

EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.

This can cause them to overheat, burn or burst.

Never throw batteries into fire or water. The

batteries may explode.

Remove spent batteries from the product imme-

diately. Otherwise there is an increased risk of
leakage.

Always replace all the batteries at the same

time and insert batteries of the same type.

Do not use different types of batteries or mix

used and new batteries together.

Check regularly that the batteries are not leaking.

Leaked or damaged batteries can
cause chemical burns if they come
into contact with the skin; in such

cases you must wear suitable protective gloves!

Do not let the fluid from a leaking battery come

into contact with your skin, eyes or mucous
membranes. In the event of contact with fluid
leaking from a battery, thoroughly flush the

affected area with water and / or seek the
advice of a doctor!

Remove the batteries from the product if it is

not in use for any length of time.

Make sure you insert the batteries the right

way round (polarity). The correct polarity is
shown inside the battery compartment.

If you disregard these instructions and advice,

the batteries may discharge beyond their mini-
mum voltage, thus increasing the chance of
leakage. If your batteries leak, remove them
from the device immediately to prevent it from
being damaged.

If necessary, clean the contacts on the batteries

and on the device itself before inserting them.

Batteries do not belong in household refuse.

Dispose of used batteries in an environmentally
friendly manner.

Preparing for use

Inserting or replacing batteries

Rotate the candle holder

3

clockwise until the

fixing

4

releases (see Fig. A).

Pull the candle holder

3

out of the lamp

body

1

.

Pull the LED candle

2

out of the candle

holder

3

.

Remove the battery compartment cover

5

from the underside of the LED candle

2

(see Fig. B).

Remove the used batteries, if present.
Insert the 3 supplied or new batteries (AAA,

1.5 V

) into the battery compartment.

Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.

Close the battery compartment cover

5

.

Insert the LED candle

2

back into the candle

holder

3

.

63794_mel_Dekoleuchte_mit_LED_Content_DE-FR-NL-DK-SI-IT-GB.indd 25

13.05.11 16:00

Advertising