Epson WorkForce 600 Series - Manual (Page 41)

Replacing Ink Cartridges 41
3. Squeeze the tab on the cartridge and lift it straight
up. Dispose of it carefully. Do not take the used
cartridge apart or try to refill it.
Warning:
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets into your eyes, flush them
immediately with water. Keep ink cartridges out of the
reach of children.
4. Shake the cartridge several times,
then remove it from the package.
Do not to touch the green chip on
the side.
5. Remove the yellow tape from the
bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push it down until it clicks
into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Close the scanner.
9. Press OK to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
Caution:
To conserve ink, never turn off the WorkForce 600 Series while ink is charging. If you
see an ink replacement message on the display screen, press OK and press down all
the cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.