Eicon Networks Diva 2440 - Manual (Page 64)

Command Line Reference Page 64
DHCP Commands
SET DHCP TYPE <SERVER | RELAY | NONE>
Sets the type of DHCP services provided to other network devices. The DHCP server is
enabled by default.
SHOW DHCP STATUS
Displays DHCP server status and a list of currently-defined IP addresses.
SET DHCP IPRANGE <startIPaddress> <range>
Defines the pool of addresses used to assign dynamic addresses when operating as a DHCP
server.
Example: If the starting address is set to 192.168.1.2 and the range is set to 10, addresses
192.168.1.2 to 192.168.1.11 are available for DHCP.
SET DHCP LEASEDURATION <duration> <MINS | HOURS | DAYS>
Defines the length of time a client address assigned by the DHCP server is valid.
SET DHCP DNS <PRIMARY | SECONDARY> <ipaddress>
Defines the primary and secondary DNS server addresses sent to a DHCP client when a
DHCP lease is requested. By default, the primary DNS is 192.168.1.1 (this is the default
address of the device); the secondary is blank.
SERVER IP addresses will be dynamically assigned when a DHCP request is
received from a network device.
RELAY Relays DHCP requests to a separate DHCP server (use SET DHCP
SERVERADDR to specify).
NONE DHCP requests are ignored.
<startIPaddress> Starting address for the pool. This address must be on the same
network as the LAN IP address. Default: 192.168.1.2.
<range> Number of addresses in the pool. Range: 1-250. Default: 250.
Range 30 minutes to 30 days.
<PRIMARY> Primary DNS server.
<SECONDARY> Secondary DNS server.
<ipaddress> IP address of the DNS server.