Eureka 2900 Series - Manual (Page 8)

8 1-800-282-2886
To Clear Blockages in Hose
NOTE: Turn off the switch and unplug the electrical cord
before clearing hose.
1. Firmly pull the end of the hose from the hose retainer on
the hood of the vacuum.
2. Check for blockages in the hose and hose retainer.
Flexing the hose may help loosen any blockage. If no
blockage is found, continue to step 4.
If blockage is found, clear the blockage and replace
the hose in the hose retainer. If the blockage is in the
hose retainer and cannot be cleared, continue to
step 3.
3. Remove the hood from the cleaner and check for a
blockage in the brush roll area. Make sure the hose inlet
is clear.
If no blockage is found, continue to step 4.
After the blockage is found and cleared, replace the
hood on the cleaner.
4. Twist the hose from the coupling elbow on the back of
cleaner. Check for blockages at cleaner opening and
in hose. If a blockage is found, clear the blockage. The
two screws attaching the clear hose adapter can be
removed for better access to a blockage.
5. Screw the hose back onto the back of the cleaner and
replace the other end of the hose into the hose retainer
on the hood of vacuum.
Hose
Hose
Retainer