Sealey GV180WM - Manual (Page 3)

 Warning! Do not plug in the power cord to the power outlet. Make sure the plug is disconnected before assembling the vacuum.
5.1. mounting racK anD Storage aSSemBlY
5.1.1. Do not mount the rack more than 1.5mtr from the floor.
5.1.2. Mount the vacuum into brick or the studwork of a dry wall.
5.1.3. Do not hang from or sit on the mounting rack.
5.1.4. Do not exceed the 18.16kg maximum weight.
5.1.5. insert the steel rod into the hose holding rack (fig.3.5a & fig.3.5b) and snap into place. Make sure the buttons on the rod are facing
towards you.
5.1.6. Locate the two openings on the bottom of the mounting and insert the wire accessory storage into the mounting rack until they lock into
place. Make sure the wire accessory storage is directed towards the front of the mounting rack. (fig.3.6).
5.1.7. insert the steel rod of the hose holding rack into the two holes located on the top of the mounting rack. (fig.3.7).
5.1.8. choose a wall that is not more than 5.5mtr away from an electrical outlet. use the Mounting rack Hole template (see section 9) to
align the three screw holes into a sound wall. Make sure it is level, drill 3mm pilot holes and secure the rack onto the wall using the
three screws provided. (fig.3.8).
5.2. mounting the vacuum onto the racK
5.2.1. the vacuum comes ready for dry vacuum cleaning. if the cartridge filter is not installed refer to 7.2. (fig.3.9 & fig.3.10).
5.2.2. for improved dust filtering fit the dust collection bag flange onto the inlet stub, taking care not to damage the bag. (fig.3.11).
5.2.3. for wet vacuuming install the supplied foam filter. (fig.3.12) see 7.4 for filter installation.
5.2.4. Place the power head onto the container, and secure with the two side latches. (fig. 3.13 & 3.14).
5.2.5. Mount the vacuum onto the mounting rack by aligning the vacuum hanging hook on the rear, with the slot on the mounting rack and
slide downwards until it locks. (see 3.15).
5.2.6. Wind the excess power cord around the cord wrap hooks located on the side of the vacuum. (fig.3.16).
5.2.7. insert the locking end of the hose into the vacuum port and lock it into place. (fig.3.17).
5.2.8. secure an accessory onto the end of the hose.

Warning! Do not vacuum drywall dust, soot or ash. this is very fine dust which will not be captured by the filter and may cause
damage to the motor and void the warranty.
5.3 removing the vacuum From the racK
5.3.1. Disconnect the power cord from the electrical outlet.
5.3.2. Lift the vacuum up and out of the rack by its handle.
fig.3
5. aSSemBlY
Original Language Version GV180WM issue no.2(i) 02/04/15 © Jack sealey Limited