Sealey BOOST120 User Manual
Page 4
5. SIMULTANEOUS chARgINg
5.1. A number of batteries may be charged at the same time. to do so we recommend
parallel connection as shown in fig.3A.
5.2. two 12Volt batteries may be charged simultaneously in series using a 24Volt output
charger as shown in fig.3B. this is only recommended if both batteries are of similar
capacity and in a similar state of discharge.
6. SAFETY FUSE
the charger is equipped with a fuse which will protect the unit in the following circumstances:
a) overload: too high a current to the battery.
b) short circuit: clamps touch, or cross-connection to battery.
c) Prolonged starting attempts.
If the fuse blows take the following action:
6.1. turn the unit off and disconnect from the mains power supply.
6.2. Allow the unit to cool down, establish the reason for failure and correct the situation.
6.3. replace the fuse (behind cover below ammeter), using only sealey replacement parts.
DO NOT use a fuse with a copper bridge or similar as this will damage the equipment. refer to section 2 for fuse part numbers.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey group,
Kempson Way, suffolk Business Park
,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
Boost120, Boost140, Boost160, Boost200 Issue: 1 - 15/05/12
Environmental Protection.
recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner which is compatible
with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way. contact your local solid
waste authority for recycling information.
fig.3