Epson S1C33210 - Manual (Page 120)

APPENDIX A <REFERENCE> EXTERNAL DEVICE INTERFACE TIMINGS
A-106 EPSON S1C33210 PRODUCT PART
A.6 8255A
8255A interface setup examples
Operating Read cycle
Write cycle
Output disable
frequency Wait cycle Read cycle delay time
20MHz 9
∗
1 10 10 3.5
25MHz 11 12 12 3.5
33MHz 14 15 15 3.5 ∗ 2
8255A interface timing
SRAM interface 33MHz 25MHz 20MHz
Parameter Symbol Min. Max. Cycle Time Cycle Time Cycle Time
<Read cycle>
Read cycle time t RC 300 – 15 450 12 480 10 500
Address access time t ACC – 250 15 450 12 480 10 500
#CE access time t
ACS – 250 15 450 12 480 10 500
#OE access time t OE – 250 14.5 435 11.5 460 9.5 475
Output disable delay time t OHZ 10 150 3.5 105 3.5 140 3.5 175
<Write cycle>
Write cycle time t WC 430 – 15 450 12 480 10 500
Address enable time t
AW 400 – 14.5 435 11.5 460 9.5 475
Write pulse width t
WP 400 – 14 420 11 440 9 450
Input data setup time t DW 100 – 14 420 11 440 9 450
Input data hold time
∗
3
t
DH 30 – 0.5 15 0.5 20 0.5 25
∗
1 The S1C33210 enables up to 7 cycles of wait-cycle insertion. If a number of wait cycles more than 7 cycles
needs to be inserted, input the #WAIT signal from external hardware. Note that the interface must be set for
SRAM type devices to insert wait cycles using the #WAIT pin. (Refer to "BCU (Bus Control Unit)" in the
"S1C33210 FUNCTION PART", for more information.)
∗
2 This setting cannot satisfy the 150 ns of output-disable delay time specification required for the 8255A. When
implementing such a low-speed device in the system, the external bus must be separated by inserting a 3-state bus
buffer at the output side (when viewed from the CPU) of the external system bus.
∗
3 If the data hold time that can be set is not sufficient for the device, secure it by connecting a bus repeater to the
external data bus D[15:0] or by inserting a latch at the output side of the external system interface.