Livarno Z31170A Z31170B - Manual (Page 14)

14 GB/MT
Never throw batteries into fire or water. The
batteries may explode.
Always replace all batteries at the same time
and only use batteries of the same type.
Do not use different types of batteries or mix
used and new batteries together.
Check regularly that the batteries are not leaking.
Leaked or damaged batteries can
cause chemical burns if they come into
contact with the skin; in such cases
you must wear suitable protective gloves!
Remove the batteries from the product if it is not
in use for any length of time.
Make sure that the polarity is correct when you
insert the batteries! This is indicated in the battery
compartment. The batteries can otherwise explode.
Remove used batteries from the device. Very old
or used batteries may leak. The chemical fluid
can damage the product.
Bringing into use
Inserting / replacing the batteries
Note: Remove the insulating strips before using the
product for the first time.
Turn the battery compartment cover 3 anticlock-
wise and take it off the battery compartment 5
(see Fig. A).
Insert the (new) batteries into the battery
compartment.
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.
Put the battery compartment cover back in
place on the battery compartment and turn it
clockwise to tighten it (see Fig. B).
Installing the light
Pull off the protective film from the self-adhesive
pad 6 of the battery compartment cover 3
(see Fig. C).
Attach the light in the desired location.
Note: The substrate should be dry, smooth and
free of dust and grease.
Switching On / Off
Press the light in the middle to switch it on or off.
Cleaning and care
Use a dry cloth to clean the light – never use
petrol, solvents or cleaners that attack plastic.