Livarno Z30802A-BS Z30802B-BS User Manual
Page 5
5
GB/IE
you could suffer an electric shock.
J
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 - 240 V ~).
J
Never let the lamp come into contact with
water or other liquids.
J
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.
J
Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply.
J
If the external flexible cable of this lamp is
damaged, it may only be replaced by a special
cable or a cable that is only available from the
manufacturer or his service representative.
J
Use only the original power supply cable
12
to connect the under-cabinet light to the mains
current.
J
Connect only original under-cabinet lights of
the same type (Model Z30802A-BS /
Z30802B-BS) with each other. To do so, use
only the original connection cable
7
supplied.
J
Connect the under-cabinet lights that are linked
up together to one socket only. Make sure that
you only connect a maximum of 10 linked-up
under-cabinet lights of the same type to one
socket. Otherwise this might overload the con-
nections and cables.
J
Make sure that all under-cabinet lights are
linked up via connecting cables before inserting
the power supply cable
12
into the socket.
To avoid danger of fire
and injury
m RISK OF InJURY! Immediately after un-
packing the lamp, check the lamp housing
3
,
the protective glass
10
as well as the power
supply cable
12
and, if need be, the connec-
tion cable
7
for damage. Do not install the
lamp if you discover any damage. If anything
is damaged, contact the service centre to
arrange a replacement.
RISK OF InJURY FROM bURnS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Light bulbs develop
a great deal of heat.
J
Do not touch bulb components or bulbs as they
can reach temperatures higher than 90 °C
during operation.
J
Allow the light to cool down completely before
replacing a defective bulb.
J
Replace defective bulbs immediately. Before
replacing the bulb always remove the mains
plug from the socket.
J
If a protective glass cover breaks have it replaced
immediately at the service centre or by an elec-
trician.
J
Do not operate this light with a dimmer or an
electronic switch. It is not suitable for this mode
of operation.
J
0.2 m
FIRE hazaRD! Fit the light so
that it is at least 0.2 m away from
the material illuminated. Fire can
result from the development of too much heat.
J
Never leave the light operating unattended.
J
Do not allow any objects to cover the light. Fire
can result from the development of too much heat.
J
Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
J
Use a 230 volt ~ T5 fluorescent tube type bulb
with a maximum power output of 13 watt.
J
Fit the light in such a way to ensure it is
protected from damp and dirt.
J
Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily to
hand.
J
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
89215_livx_Energiespar-Unterbauleuchte_Content_BS.indd 5
22.02.13 09:07