Livarno 104000-14-02-BS - Manual (Page 11)

11 GB/IE
your product, immediately re-
move batteries to prevent
product damage!
Batteries must not be dis-
posed of in the normal do-
mestic waste!
Every consumer is legally
obliged to dispose of batter-
ies properly.
Mounting
(see fig. a)
note: Clean the surface well
onto which you wish to mount the
product. The surface must be
clean, free from grease and dry.
The adhesion of the double-sided
adhesive strip
5 , 10 may other-
wise be limited.
note: Before use, check on a
hidden area of the surface,
whether the adhesive can cause
damage.
Peel the protective film off the
adhesive strip on the back of
the LED strip
2 and secure
the LED strip in the desired
location.
Secure the LED driver 4
with the included double-
sided adhesive strip
5 or
the included screws 8 .
Connect the power supply
3 with the LED driver.
Then connect the LED driver
to the LED strip using the
eight-pin plug
9 .
note: When connecting the
LED driver with the LED strip,
be sure to match up the
VGGD mark on the LED
driver and the VCC-GND-
GND-DI mark on the LED strip.
Be sure the power supply is
always accessible.
Plug the power supply into
the socket before switching
the product on.
Connecting 2 LED
strips (see fig. B)
note: Up to two 5 m LED strips
may be connected using the
eight-pin plug
9 and operated
with the LED driver 4 and a
power supply 3 . Otherwise