Battery safety instructions, Bringing into use, Inserting / replacing the batteries – Livarno Z29538A /Z29538B User Manual

Page 14: Installing the light

Advertising
background image

14 GB/MT

14 GB/MT

Battery Safety Instructions

DANGER TO LIFE! Keep

batteries out of the reach of children. Do not
leave batteries lying around. There is a risk of
children or animals swallowing them. Consult a
doctor immediately if a battery is swallowed.

J

EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.

This can cause them to overheat, burn or burst.
Never throw batteries into fire or water. The
batteries may explode.

J

Remove spent batteries from the product
immediately. Otherwise there is an increased
risk of leakage.

J

Always replace all batteries at the same time
and only use batteries of the same type.

J

Do not use different types of batteries or mix
used and new batteries together.

J

Check regularly that the batteries are not leaking.

J

Leaked or damaged batteries can
cause chemical burns if they come into
contact with the skin; in such cases

you must wear suitable protective gloves!

J

Remove the batteries from the product if it is not
in use for any length of time.

J

Make sure that the polarity is correct when you
insert the batteries! This is indicated in the battery
compartment. The batteries can otherwise explode.

J

Remove used batteries from the device. Very old
or used batteries may leak. The chemical fluid
can damage the product.

Q

Bringing into use

Q

Inserting / replacing the batteries

Note: Remove the insulating strips before using the
product for the first time.
Note: Switch the product off before you insert or
remove the batteries.

j

Turn the battery compartment cover

3

anticlock-

wise and take it off the battery compartment

2

(see Fig. A).

j

Insert the (new) batteries into the battery
compartment.
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.

j

Put the battery compartment cover back in
place on the battery compartment and turn it
clockwise to tighten it (see Fig. B).

Q

Installing the light

j

Pull off the protective film from the self-adhesive
pad

4

of the battery compartment cover

3

(see Fig. C).

Advertising