Livarno 101449-14-01-BS - Manual (Page 17)

17 GB/MT
CAUTION! RISK OF FIRE! Never expose the
magnifier to direct sunlight or other light sources.
Never leave an open magnifier unattended. Doing
so presents a fire hazard due to bundled light rays and con-
centrated heat.
Before use
Insert the screw clamp into the bracket 1 (Fig. A). Secure the
screw clamp into the bracket using the lock screw 3 (Fig. B).
Now place the screw clamp onto a table top ≤ 6 cm in thickness
and secure the screw clamp by turning the screw clockwise
(Fig. C).
Insert the articulated arm 7 into the round hole on the bracket
and secure by tightening the wing bolt 5 clockwise (Fig. D).
Verify the articulated arm is firmly tightened in the bracket.
Using the LED magnifier light
Plug the mains plug of the light into a properly installed socket.
Move the ON / OFF switch
9 into the I position to switch the
light on.
Move the ON / OFF switch into the 0 position to switch the
light off.
Adjusting the LED magnifier light
Never use force when adjusting the light.
The light can be adjusted in different ways:
· The lamp head is pivot-mounted inside the ball joint 8 (Fig. F).
· After loosening the lock screw 6 you can adjust the lamp
head up or down. Tighten the lock screw after adjusting the
light to the desired position.
· The individual parts of the articulated arm 7 can be moved
by the joints 4 .
Using the magnifier
Lift the cover 10 to use the magnifier.
Focus the object you wish to view by changing the distance to the
object and the distance between your eyes and the magnifier.
101449_livx_LED-Lupenleuchte_Content_ES_IT.indd 17 13.08.14 17:18