Battery safety instructions, Bringing into use, Inserting / replacing the batteries – Livarno 102733-14-01/102733-14-02 User Manual

Page 17

Advertising
background image

17

GB/MT

J

Do not subject the device to any extreme
temperatures or severe mechanical stress.
Otherwise this may result in deformation of the
product.

J

The lamps are only intended for use
indoors, in dry and enclosed areas.

Battery Safety Instructions

DANGER TO LIFE! Keep

batteries out of the reach of children. Do not
leave batteries lying around. There is a risk of
children or animals swallowing them. Consult a
doctor immediately if a battery is swallowed.

J

EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.

This can cause them to overheat, burn or burst.
Never throw batteries into fire or water. The
batteries may explode.

J

Remove spent batteries from the product
immediately. Otherwise there is an increased
risk of leakage.

J

Always replace all batteries at the same time
and only use batteries of the same type.

J

Do not use different types of batteries or mix
used and new batteries together.

J

Check regularly that the batteries are not leaking.

J

Leaked or damaged batteries can
cause chemical burns if they come into
contact with the skin; in such cases

you must wear suitable protective gloves!

J

Remove the batteries from the product if it is not
in use for any length of time.

J

Make sure that the polarity is correct when you
insert the batteries! This is indicated in the battery
compartment. The batteries can otherwise explode.

J

Remove used batteries from the device. Very old
or used batteries may leak. The chemical fluid
can damage the product.

Q

Bringing into use

Q

Inserting / replacing the batteries

Note: Remove the insulating strips before using the
product for the first time.
Note: Switch the product off before you insert or
remove the batteries.

j

Turn the battery compartment cover

3

anticlock-

wise and take it off the battery compartment

2

(see Fig. A).

j

Insert the (new) batteries into the battery
compartment.
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.

102733_livx_Pushleuchte_Content_ES_IT_PT.indd 17

10.07.14 15:50

Advertising