Livarno 2592 - Manual (Page 26)

25 GB/MT
Safety / Preparation
to avoid danger to life
from electric shock
J Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
m cAUtIon! A damaged mains lead presents
a serious danger to life from electric shock.
In the event of damage, repairs or other problems
with the lamp please contact the service centre
or an electrician.
J Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 - 240 V ~).
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing
can lead to a serious danger to life from
electric shock.
J Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply.
to avoid danger of fire
and injury
J rISk oF InjUry! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not operate the light with a defec-
tive bulb or glass cover. If they are, contact the
service point for a replacement.
J rISk oF InjUry FroM bUrnS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Light bulbs develop
a great deal of heat.
J Do not touch bulb components or bulbs as they
can reach temperatures > 90 °C during
operation.
J Allow the light to cool down completely before
replacing a defective bulb.
J Replace defective bulbs immediately. Before
replacing the bulb always remove the mains
plug from the socket.
J If a protective glass cover breaks have it re-
placed immediately at the service centre or by
an electrician.
J Do not operate this light with a dimmer or an
electronic switch. It is not suitable for this mode
of operation.
J
0,2 m
FIrE HAzArD! Fit the light so
that it is at least 0.2 m away from
the material illuminated. Fire can
result from the development of too much heat.
J Never leave the light operating unattended.
J Do not allow any objects to cover the light. Fire
can result from the development of too much heat.
J Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
J Use a 230 - 240 volt T5 fluorescent tube type
bulb with a maximum power output of 13 watt.
J Fit the light in such a way to ensure it is
protected from damp and dirt.
J Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily to
hand.
J Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Q Preparation
Q required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.
- Pencil / Marking tool
- Screwdriver
- Drill
- Spirit level
37841_Content_LB5new.indd 25 17.07.09 09:42