Livarno 2592 - Manual (Page 9)

8 GB
Q
Preparations for use
Q fitting the light
j Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
j Mark the two mounting holes a distance of
410 mm apart.
j Now drill the mounting holes (Ø approx. 5 mm,
depth approx. 30 mm). Make sure that you do
not damage any electrical cables during this
operation.
j Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them. Let them project a distance of
about 1.3 mm from the wall or mounting
surface.
j Attach the light using the appropriate mounting
holes 4 or 5 to the screws.
j Insert the light connector plug of the mains
lead 9 into the light connector socket 1 .
j Insert the mains plug of the mains lead 9 into
a convenient mains socket. Your light is now
ready for operation.
Q Switching on / off
j Switch the ON / OFF switch 2 to turn the light
on or off.
Q Directing the light
j Never change the direction of the light while it
is switched on.
m CaUTIon! DangER of bURnS! Do not
touch bulb components or bulbs as they can
reach temperatures > 90 °C during operation.
j Allow the light to cool down completely.
j Turn the strip light 6 into the desired direction.
The strip light can pivot through about 45 °.
Q Changing the bulbs
c CaUTIon! DangER of ELECTRIC
ShoCk! To replace the bulb 8 , first of all
disconnect the light from the mains circuit. To do
this pull the mains plug on the mains lead
9
out of the socket.
j Allow the lamp to cool down completely.
j Use a clean, lint-free cloth when changing light
bulbs.
j Pull the protective glass cover 7 out of the
guides on both sides. Place the protective glass
cover carefully to one side.
j Fold out the plastic clips on the right and left.
j Rotate the bulb 8 ¼ turn and pull it out of the
fitting.
j Use a 230 - 240 volt T5 fluorescent tube type
bulb with a maximum power output of 13 watt.
j Insert a new bulb carefully into the fitting and
turn it through ¼ turn to fix it in place. Check
that it is correctly seated.
j Fold the plastic clips back into place until they
engage.
j Shift the protecting glass disk 7 (smooth page
should indicate outward) again into the guide
rail.
j Turn the strip light 6 into the desired direction.
j Insert the mains plug on the mains lead 9
back into the socket. Your light is now ready
for operation.
Q
Maintenance and Cleaning
c CaUTIon! DangER of ELECTRIC
ShoCk! To do this pull the mains plug on the
mains lead
9 out of the socket.
j Allow the lamp to cool down completely.
c CaUTIon! DangER of ELECTRIC
ShoCk! For reasons of electrical safety, the
light must never be cleaned with water or other
fluids or be immersed in water. When cleaning,
only use a dry, lint-free cloth.
j Do not use any solvents, petrol or similar. This
would cause damage to the light.
Preparations for use / Maintenance and Cleaning
37841_Content_LB4.indd 8 21.07.09 16:41