Livarno 2356/042L - Manual (Page 7)

7 GB
To avoid danger to life
from electric shock
J Ensure that a qualified electrician or a person
trained to carry out electrical installations per-
forms the electrical installation.
J Never use the light if you discover that it is
damaged in any way.
J In the event of damage, repairs or other problems
with the lamp please contact the service centre
or an electrician.
J Before fitting, switch the electricity off at the
fuse box or remove the screw retention devices
in the fuse box.
J Never let the lamp come into contact with
water or other liquids.
J Never open any electrical fittings such as in-line
switches, transformers etc. or allow any object
to be inserted into them. This sort of interference
can lead to a serious danger to life from
electric shock.
J Before installation ensure that the available
mains voltage agrees with the operating volt-
age specified for the lamp (230 - 240 volt ~).
To avoid danger of
fire and injury
J RISk of InjuRy! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not fit the light if the bulbs and/or
lampshades are faulty. If they are, contact the
service point for a replacement.
J RISk of InjuRy fRoM BuRnS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
J Allow the lamp to cool for at least 15 minutes
before replacing a defective bulb.
J Replace any faulty bulbs with new ones imme-
diately. Before replacing the bulb, always re-
move the fuse or switch the automatic cutout off.
J fIRe hazaRD! Fit the light so that it is at least
0.5 m away from the material illuminated. Fire
can result from the development of too much heat.
J Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
J Only use 230 - 240 V ~ bulbs with a E 14 base
and a maximum output of 40 Watts.
J Install the light so that it is protected from
moisture and dirt.
J Make careful preparations for the assembly
and take sufficient time. Clearly lay out all
components and any additional tools or mate-
rials that might be required so that they are
readily to hand.
J Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Q
Preparation
Q
Required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.
- Pencil / Marking tool
- Voltage tester
- Screwdriver
- Drill
- Edge cutter
- Ladder
Q Before installation
Important: The electrical connection must be
carried out by a qualified electrician or someone
trained to perform electrical installations. This per-
son must be familiar with the features of the light
and the connection requirements.
Safety / Preparation / Before installation