Livarno 1307-022L - Manual (Page 19)

19 GB
Safety advice Start-up / Maintenance and Cleaning / Disposal
Start-up
Mounting the light
Attach the plastic sleeves 7 onto the stand
tubes 14 (model 1308-022L).
Insert the tubes of the floor lamp 14 into the
pre-mounted holes in the base 13 .
Place the serrated lock washers 8 at the
underside of the base 13 onto the tubes 14 .
Screw the nuts 9 clockwise onto the tubes 14
using the open-end spanner 10 to secure the
floor lamp to the base 13 .
Ensure the cables are inside the designated
opening in the base 13 and cannot be
crushed.
Secure the input lead using the strain relief 11 .
Tighten the strain relief 11 using the screws 12 .
Apply the felt cover to the bottom of the base 13 .
Place the uplight dome 1 onto the tube.
Connect the input lead from the base 13 to the
wall power supply 6 .
Plug the mains plug into a socket that has been
professionally installed.
Your light is now ready for operation.
Switching the lamp on / off
Switch the uplight on or off by turning the
ON/OFF rotary switch 5 to the right / left
(see Fig. A).
Use the ON/OFF switch 3 to switch the
reading lamp on and off.
Dimming the ceiling floodlight
Dim the light of the ceiling floodlight by turning
the ON / OFF rotary switch 5 to the
right / left.
Note: The light is always set at the lowest
dimming level when it is switched on.
Adjusting the lamp (see fig. B)
Loosen the height adjustment screw 15 and set
the required height for the ceiling floodlight.
Note: You can adjust the height of the ceiling
floodlight between 1.10 m and 1.80 m.
Re-tighten the height adjustment screw 15 in
order to fix the ceiling floodlight at the required
height.
Bend the flexible arm 2 of the reading lamp
in the required direction.
Do not rotate the flexible arm 2 of the reading
lamp completely. Otherwise the mains cable
inside the lamp could be damaged.
The up-light is hinged and pivoted. Tilt the
up-light to the desired angle.
Maintenance and Cleaning
DANGER OF ELECTRIC SHOCK! First remove
the mains plug from the socket.
CAUTION! DANGER OF BURN INJURIES!
Allow the lamp to cool down completely.
DANGER OF ELECTRIC SHOCK! For elec-
trical safety, never clean the light with water or
other fluids, or immerse it in water.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
Only use a dry, lint-free cloth for cleaning.
Disposal
The package and packaging materials
consist entirely of environmentally
friendly materials. They can be disposed
of at your local recycling facility.
The symbol of the wheelie bin with the
line through it means that, in the Euro-
pean Union, the product has to be
disposed of in a separate refuse collection. This ap-
plies to the product and to all components bearing
this symbol. Do not dispose of products bearing this
symbol in your normal household waste, but
instead they must be taken for recycling to a